Artificial Grass Installation Guide

General Overview of the Synthetic Lawn Grass Installation Process:

(Please Note: Different environments can require different sub-base installation procedures.)

  1. Mark off the area/s where you're installing the Eco Grass artificial lawn.

  2. Remove sod.

  3. Cap sprinklers and turn off valves.

  4. Compact existing ground to firm it fully."

  5. Apply weed/grass killer and place a weed barrier mesh down.

  6. Create a 25mm-75mm sub-base.

  7. Spread and then compact the sub-base material.

  8. Apply top-based sand.

  9. Check surface for depressions. Any depression areas 3 - 6.5mm or deeper should be filled and re-leveled. Although the turf also drains vertically through the manufactured drainage holes, it is still advisable to give the sub-base a slight slope to avoid any pooling (slope away from buildings).

  10. Roll out turf. Position the turf accurately.

  11. Make sure the turf is in the proper position; then cut off any excess material so the entire piece is easier to work with.

  12. Create seams. The seams are simply glued together with our recommended outdoor seam tape glue and special seaming material.

  13. Apply the infill using a standard seed drop spreader. This helps weigh the turf down, avoid turf wrinkling and stabilize the fibers. Most dealers use sand or rubber infill.

  14. Create optional edging. Depending on your yard, you may want to install some type of edging material around the edges. Concrete curbing, natural stone, rock borders and metal or plastic edging (similar to what is used around flower beds) are popular.

 

 

WHY ARTIFICIAL TURF?

PROFESSIONAL FINISH

LAY IT YOURSELF

HARD WEARING

LONG LASTING

COST EFFECTIVE

SAMPLE REQUEST

YOUR NAME:
ADDRESS:
POST CODE:
PHONE:
EMAIL ADDRESS:
TYPE: